Connection To Ac Outlet; Convenience Outlets - Marantz 2235B Handbook Of Instructions

1. Complete the necessary signal connections so
that program material may be played rhrough
the sDeakers,
2. Place the soeakers in the center of the room.
3. Depress the MONO pushswitch and play a
record (or radio or tape) with strong bass tones
at a low volume level, Genter the BALANCE
control.
4, Position the speakers about six inches apart,
face-to-tace, Listen, particularly to the ap-
parent loudness of the bass tones.
5. Next, turn off all power, but do not disturb the
VOLUME or BALANCE settings. Reverse the
connections on the right speaker only, Turn on
the power and listen again. lf the bass tones
now seem louder than in (3), you have correct-
ed the phasing between the speakers. lf the
bass notes now sound softer, turn off the
power and reconnect the speakers as they had
been originally.
6, lf an additional pair of speakers is connected,
and if they are intended to be used in the same
room as the main speaRer, check phasing
between the remote soeakers and the main
speakers. Use the BALANCE control to play
only two speakers at once, and invert the
wiring on the remote speakers as necessary. Do
not change the connections on the main
speaker system.
7. Once having phased all speakers, you need not
repeat this procedure in the future if you now
mark the speaker connections and/or cables.
Any method of coding is satisfactory, provided
it enables you, in the future, to duplicate your
now{orrect hookup between speakers and
amolif ier.
Use caution when connecting your Model 22358
to a loudspeaker with built-in power supply such
as an electrostatic loudspeaker. The "common"
connection terminal of such a speaker may be
capacitively coupled to ground through its own
power supply. To protect the Model 22358 from
distortion and possible overload, make sure the
Figure 5.. 0pelation of Speaker Terminals
(-) terminals of the Model 22358 are connected
to the "common" terminals of such a loudsoeaker
system,
CAUTION: NEVER DIRECTLY CONNECT
THE LOUDSPEAKER TERMI-
NA LS OF ONE CHAN N EL I N
PARALLEL WITH THOSE OF
ANY OTHER. ANY RESULTING
DAMAGE IS NOT COVERED
UNDER WARRANTY.
NOTE:
Do not use 4 ohm speakers if main
and remote speakers are to be used
simultaneously, Use I or 16 ohm
speakers only.
CONNECTION TO AC OUTLET
With the front panel POWER pushswitch "out".
plug the line cord into an electrical outlet
supplying the proper voltage.
CAUTION: Do not exceed the maximum total
power ratings of the AC outlets. The
POWER switch and other circuitry in
the 2235tJ may suffer damage if
forced to conduct excessive current.
CONVENIENCE OUTLETS
One UNSWITCHED and one SWITGHED AC
OUTLETS are provided on the rear panel for
powering associated components of yout system
(tape recorder, record player, etc.).