Security Code; Phone Settings - Renault Radio Classic Manual

SYSTEM SETTINGS
Default settings
To return to the default settings:
– display the settings menu by press-
ing the 12 button on the front panel
of the audio system;
– select the "parameters" menu using
the 11 knob on the front panel of the
audio system;
– press the 11 knob on the front panel
of the audio system to display the
settings menu, then select "Default
audio".
A message will appear on the audio
system display asking you to confirm
your selection. After selecting this item,
all the audio system settings return to
their default values.

Phone settings

To display the phone settings menu,
press the 8 button on the front panel of
the audio system or 19 button on the
steering column control.
(2/2)
The system automatically exits the
menu if there is no activity for a few
seconds. You can also exit the menu by
pressing the 9 button on the front panel
of the audio system.

Security code

Your audio system is protected by a se-
curity code (supplied by the Approved
Dealer). This is used to electronically
lock the audio system when the power
is cut (battery disconnected, system
disconnected, fuse blown etc.).
To operate the audio system, you must
enter the secret four-digit code.
Make a note of the code and keep it in a
safe place. If you lose it, please consult
an approved dealer.
Entering the code
To enter the code:
– press the 1 button on the front panel
of the audio system to switch on the
system. The message "CODE" fol-
lowed by "0000" will appear on the
display;
– to set the value of the first flashing
digit, press button 1 on the 7 keypad
on the front panel of the audio
system until you reach the desired
number;
– set the following digits on buttons 2,
3 and 4 of the 7 keypad on the front
panel of the audio system in the
same way.
After selecting the fourth digit, press
and hold button 6 on the 7 keypad on
the front panel of the audio system.
The system is unlocked automatically
once the full code has been entered.
Entering the code incorrectly
If there is an error when entering the
code, the message "CODE ERROR...
WAIT" will appear on the audio system
display.
Wait around 60 seconds then re-enter
the code.
Each time the code is entered incor-
rectly, the time required before the code
can be re-entered is doubled.
GB.29