Adjustments Using The Set Up Button - Sony STR-DB1070 Operating Instructions Manual

Tip
• You can freely specify the time. After pressing
SLEEP, specify the time you want using the jog dial
and cursor buttons ( or
sleep time changes in 1 second intervals. You can
specify up to 5 hours.
• To check the remaining time before the receiver
turns off, press SLEEP. The remaining time
appears in the display.
Adjustments using the
SET UP button
The SET UP button allows you to make the
following adjustments.
1
Press SET UP.
2
Press the cursor buttons (
select the parameter you want to
adjust.
3
Turn the jog dial to select the setting
you want.
The setting is entered automatically.
4
Repeat steps 2 and 3 until you have set
all of the parameters that follow.
Initial settings
Parameter
6.1CH DECODING
MULTI CH (1 or 2)
D.POWER
V.POWER
S.FIELD LINK
A1 AUTO POWER
AUTO FUNCTION
1)
2ND ROOM SP
COMMAND MODE
3)
COLOR SYSTEM
4)
OSD
OSD H.POSITION 4)
4)
OSD V.POSITION
1) Only when the center or surround back speaker is
set to "2ND ROOM" (STR-DB1070 of area code
U, CA only).
2) Depends on the model.
3) STR-DB1070 of area code other than U, CA only.
4) STR-DB1070 only.
) on the receiver. The
or ) to
Initial setting
AUTO
NONE
ALWAYS ON
AUTO OFF
ON
ON
ON
OFF
2)
AV1
PAL
COLOR
4
4
x 6.1ch Matrix (6.1CH DECODING)
According to the setting, the receiver decodes
and downmixes the surround back signals to
the surround speakers for 6.1 channel encoded
sources. This parameter lets you enjoy the
appropriate surround sound from the surround
channels.
• You can set this parameter using 6.1CH
DECODING on the front panel.
• When set to "AUTO", the receiver performs
6.1 channel matrix decoding only if 6.1 channel
signals decode flag is ON.
• When set to "ON", the receiver performs
6.1 channel matrix decoding only if the
surround signals are 2 channel, regardless of the
6.1 channel decode flag.
• When set to "OFF", the receiver does not
perform 6.1 channel matrix decoding.
• During "A.F.D.", this parameter is always set to
"AUTO", and you cannot change the setting.
• When the surround back speaker is set to "NO",
the 6.1 channel matrix decoding is not
performed (SB does not light up). When the
surround back speaker is set to "YES", the
6.1 channel matrix decoding is performed (SB
lights up).
x Multi channel assignment (MULTI
CH (for STR-DB1070, MULTI CH 1 or
2))
Lets you assign a function to MULTI CH (for
STR-DB1070, MULTI CH 1 or 2). You cannot
assign TUNER or PHONO.
For STR-DB1070, you cannot assign the same
function to both MULTI CH 1 and 2.
continued
45