Sears 10853 Instructions

DO NOT RETURN THIS ARTICLE TO THE STORE
Should you encounter problems after following all the steps herein contained please contact our
customer support:
Kindly provide the model #, place and date of purchase and a short description of the problem
ASSEMBLY INSTRUCTIONS:
1. Make sure there is access to a GFCI outlet (Ground Fault Circuit Interrupter) designed for outdoor
use that can be used for an electrical supply.
2. Place the base on clean level ground that is free from debris and sharp objects. Make sure not to
place on any surface that may be damaged by water.
3. Place pump into fountain basin at the back pump cavity.
4. Place both lights in the round indents in the bottom of the basin and tip them to spot light the water
falls area. The lights are soft lighting meant to be seen at night.
5. Hook the wires into the plastic retainers to keep the wires neat.
6. The hose is curled up in the top section, pull out and set top section in place and thread the hose
through the middle hole at the same time.
7. Connect pump outlet to hose. Make sure the hose is not crimped as it will restrict the water flow.
8. Fill basin with water.
9. Plug pump into appropriate outdoor outlet. (If you are unclear about what is an appropriate outlet,
please consult a certified electrician familiar with local codes.)
10. Check water flow and examine fountain for leaks.
11. Put the pump cover in place.
12. Enjoy your fountain – please remember to keep adding water as needed. Hint: If bubbles start to
show in the water outlet, it is usually because the water is too low and the pump intake is starting to
suck in air. Add water until the air bubbles go away.
A
TTENTION
CUSTOMER SERVICE CENTER
Thank you for purchasing your new fountain.
Call 1-866-231-8893 or email:
10853 Large Rock- Look Fountain with LED lights.
info@ctm-inter.com
This fountain is for outdoor use only.