Broan CRDN1 SERIES Installation Use And Care Manual page 11

5 ] Remove the barrel nut retaining the flange of the right blower cover plate (shaded part on
illustration below) to the inner back of hood (see inset). Remove the right cover plate retaining
screws (7 screws), then set the blower cover along with its screws and nut aside.
6 ] Remove the EZ1 brackets from inside the hood by cutting off the tie wrap.
7 ] Remove Electrical Power Cable Knockout from top (vertical exhaust) or back (horizontal
exhaust) of hood. For knockout removed from back of hood, install an appropriate strain
relief, 1/2" diameter (not included). For knockout removed from top of hood, the strain relief
will be installed later.
ELECTRICAL
POWER CABLE
KNOCKOUT
5 4
6
1
7
BACK OF HOOD
3
2
EZ1
BRACKETS
11