Adjusting The Head Support; Securing Child In Vehicle With Shoulder Belt Positioning Clip; To Attach Clip To Booster Seat - Graco Junior Maxi Owner's Manual

The lap belt portion MUST pass under the armrests and
be positioned low on the hips.
Belt MUST NOT be twisted.
29
If the belt lays across child's neck, head or face, readjust head support
height. Follow instructions, "Adjusting the Head Support" .
30

Adjusting the Head Support

BEFORE adjusting the head support height, have your child lean
forward slightly.
31
Squeeze the red adjustment button on top of seat and pull back support up
until it snaps into one of the 6 height positions.
32
To lower, squeeze red adjustment button and push down.
CHECK to make sure it is securely snapped into one of the 6 height posi-
tions by pulling up on head support.

Securing Child in Vehicle with Shoulder Belt Positioning Clip

33
The shoulder belt MUST lay across child's shoulders in red zone as shown.
If shoulder belt lays outside this zone, the shoulder belt positioning clip
MUST be used.

To attach clip to booster seat:

Insert the loop end of strap around vertical bar on rear of seat as shown.
34
The shoulder belt positioning clip MUST be attached onto the vertical
bar of the base farthest from where the vehicle shoulder belt lays across the
child.
35
Pass the clip and strap through the loop end as shown and pull strap up.
NOTE: Free end of strap should face front of seat.
36
Slide the vehicle shoulder belt onto the clip as shown and pull strap down
37
to tighten clip against child's shoulder.
38
Rear view of child sitting in seat
The lap belt portion MUST pass under the armrests and
be positioned low on the hips.
The belt MUST NOT be twisted.
17