Programming example
Circular interpolation over several quadrants:
Center of arc
Value of "I"
Value of "K"
3.2.1.4
Contour definition programming and insertion of chamfers and radii
Chamfers or radii can be inserted after each traversing block between linear and circular contours, for instance for deburring
the sharp workpiece edges.
The following combinations are possible during insertion:
● between two straight lines
● between two arcs
● between an arc and a straight line
● between a straight line and an arc
Format
, C...; Chamfer
, R...; Rounding
Example
N10 G1 X9. Z100. F1000 G18
G1 X19 Z100
X31, A140, C7.5
N30 X80. Z70., A95.824, R10
26
(100.00, 27.00)
Programming and Operating Manual (ISO Turning/Milling)
01/2017