Install Remote Control Battery - Philips PD7040/12 User Manual

»
The charge indicator turns on. It takes about 7.0 hours to fully
charge the battery.
»
When the battery is fully charged, the charge indicator turns off.

Install remote control battery

Caution
•
Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard
batteries in fire.
•
Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.
•
Batteries contain chemical substances, they should be disposed of properly.
•
Perchlorate Material - special handling may apply. See www.dtsc.ca.gov/
hazardouswaste/perchlorate.
For first-time use:
1
Remove the protective tab to activate the remote control battery.
To replace the remote control battery:
1
Open the battery compartment.
2
Insert one CR2025 battery with correct polarity (+/-) as indicated.
3
Close the battery compartment.
EN 15