Diagnostic Messages - GE 469 Instruction Manual

CHAPTER 4: INTERFACES
4.1.7

Diagnostic Messages

469 MOTOR MANAGEMENT RELAY – INSTRUCTION MANUAL
 To enter a given Setpoints page, press the
 Press the
page headers until the required message is reached.
The end of a page is indicated by the message
beginning of a page is indicated by
Each page is broken further into subgroups.
 Press
the desired subgroup appears on the screen.
 Press the
Each sub-group has one or more associated settings messages.
 Press the
 Press the
settings messages, if applicable.
The majority of settings are changed by pressing the
appears, and then pressing
numeric keys (including decimals). If the entered settings is out of range, the original
settings value reappears. If the entered settings is out of step, an adjusted value will be
stored (e.g. 101 for a settings that steps 95, 100, 105 is stored as 100). If a mistake is made
entering the new value, pressing
editing is a special case described in detail in Entering Alphanumeric Text on page 4–5.
Each time a new settings is successfully stored, a message will flash on the display stating
NEW SETPOINT HAS BEEN STORED
 Press the 4, 6, 9 keys, then press
is displayed:
and the display returns to:
1. Press ESCAPE or MESSAGE
numerous times will always return the cursor to the top of the

MESSAGE
page.
Diagnostic messages are automatically displayed for any active conditions in the relay
such as trips, alarms, or asserted logic inputs. These messages provide a summary of the
present state of the relay. The Message LED flashes when there are diagnostic messages
available; press the
MENU
or

MESSAGE MESSAGE
or

MESSAGE MESSAGE
or

MESSAGE ENTER
 PASSCODE
or

MESSAGE ENTER
ENTER PASSCODE FOR
ACCESS:
or

MESSAGE MESSAGE
. Numeric settings may also be entered through the
ENTER
returns the settings to its original value. Text
ESCAPE
.
NEW SETPOINT HAS
BEEN STORED
SETPOINT ACCESS:
Permitted
to exit the subgroup. Pressing ESCAPE or

key until the relay displays
or

MESSAGE ENTER
keys to scroll through sub-

END OF PAGE
.
TOP OF PAGE
to cycle through subgroups until

key to enter a subgroup.
[]
key to enter the setting message.
keys to scroll through more

keys until the desired value
VALUE
. The following flash message
ENTER
, then press the
TARGET MESSAGES
key.
. The
4–7