Buzzer; Maximum Temperature Selection; Display Standby - Miele PW 413 Operating And Installation Instructions

Settings option
96
– t/mn
– giri/min
– kierr/min
– r/min
– omdr/min
– v/min
– o/min

Buzzer

If "Yes" is programmed, the buzzer is activated along with the pro-
gramme stop signal 1 and 2, the block end signal and the fault stop
signal. The buzzer frequency is increased with the fault stop signal.
The buzzer is switched off after 5 minutes or when a button is
pressed.
If "No" is programmed, the buzzer is switched off.
Options:
– No
– Yes

Maximum temperature selection

This value can be set from cold to 95 °C / 203 °F in 1 °C / °F incre-
ments and limits all temperature settings in the programmes to the
selected value. This means that when 60 °C is selected, for example,
the water will not be heated to more than 60 °C in any programme
even if a higher temperature is programmed for the selected pro-
gramme.
Options:
– Cold
– 15 to 95 °C

Display standby

If the "Display Standby: yes" setting is selected, the display is
switched on by pressing any button. If no further buttons are
pressed after 10 minutes, the machine returns to "Standby". The
start button light ring flashes to inform you of this. When a button is
pressed the display is switched on again and the last active screen
appears.
When "Display standby: No" is set, the display is permanently on.
Choose from the following options:

– Yes
– No