2. Operation 2.1 Power Button Press the power button to turn the device on. Press and hold the button to shut the device down. Press the power button once to turn the laser positioning light on/off (while the device is powered on). 2.2 Video/Talkback Press the video button to begin video recording and stop video recording (on/off).
2.7 Down/Left In the settings menu, press the DOWN/LEFT button to move down or to the left to make choices. Tip: Press and hold means press the button for 2-3 seconds. Press means touch the button once. 3. Indicators The indicators in power on mode or standby mode of this device are as the following chart shows.
4. Basic Functions 4.1 Power on/off Press the Power button (located in the middle of the right side) and it will enter the normal display scene. In any display state, press and hold the Power button for 3 seconds, and the device will power down. Normal display scene ...
4.3 System settings Press and hold the Photo/Menu button to enter the System settings. The following screen will appear: SYSTEM 1920*1080 | 16: 9 2014-12-18 11:30am SPLIT | SMIN 3.0m (2048*1536 | 4:3) PHOTO NUMBER: 1 1. Resolution settings: press the OK/Playback button, the item turns yellow, press the Up/Maximize button or the Down/Minimize button to choose the resolution, then press the OK/Playback button to confirm the choice.
8. Recorded video extension: press the up/down button to choose the recorded video extension item, press the OK/Playback button, the item turns yellow, press the Up/Maximize button or the Down/Minimize button to turn on/off the state, then press the OK/Playback button to confirm the choice. 9.
"View/playback video" section. 2. While recording video, press the "Photo/Menu" button once to capture a photograph; it will continue recording after saving the photo. 4.7 Audio This device can solely record audio as well. In the preview/startup menu, press the "Record/Back" button [AUD button] to begin recording. The display shows a "Recording"...
4.11 AV Output / Voice Intercom 1. AV Output The device has an AV output function. Use the AV output cable to connect to a monitor. Audio and video will play on the monitor when connected properly. The device’s display will be blank while being transmitted to an external monitor/television.
2. Installation of the battery door: as shown in the above picture, put pressure and press the battery door towards the bottom of the device. You are now free to install the battery. Place the battery door back on the device and slide upward in the opposite direction until it clicks into place.
Use of external camera: 1. Insert the external camera cable into the machine's external camera input (located on the side). 2. The machine will recognize the external camera and start external camera mode (the machine has both inside and outside automatic camera display; the priority display is the external camera).
7.2 Remote control buttons operate as follows: Photo/Menu Button: Camera button, for taking photographs. Press this button while taking a video in order to capture a photo. Video/Record Button: Video button, press this button to take a video; press it again to stop recording.
10. Specification Body Built-in Camera res resolution 1920*1080; Video Input External Camera resolution 1920*1080 Display 2.0 inch 16:9 TFT LCD | 960*240 Built-in Lens: 1080P HD 120° wide angle; Lens External Lens: 1080P HD 90° wide angle 0.3~ ∞ Focus Range CMOS 1/2.5"...
Operating -22°F~131°F / >90% Temperature Operating Power of about 270mAh, video is about 370mAh, screensaver Current about 230mAh, 420mAh IR to open Waterproof IP54 USB cable: 39.4” GPS: 15.8”-34” External lens: 30” Cable Length Operating Windows 98/2000/ME/XP/Windows 7/Windows 8 System 11....