Cassette Recorder; Basic Functions; Playing A Tape - Philips SOUNDMACHINE AZ1856 User Manual

Basic Function/ Radio

Basic functions

Switching on/off the set
1 To switch on, adjust the source selector to
DISC/USB, FM or TAPE as desired.
2 To switch off, adjust the source selector to
OFF.
Adjusting sound
Adjust the sound with the VOLUME and
DBB controls.
Radio reception
1 Push the source selector to FM
2 Turn TUNING to tune in a radio station.
3 To switch off the radio, adjust the source
selector to OFF.
Helpful hints:
To improve reception
• For FM, extend, incline and turn the
telescopic antenna. Reduce its length if the
signal is too strong.

Cassette Recorder

Playing a tape

1 Set the source selector to TAPE.
9 /
2 Press to open the cassette holder.
3 Insert a recorded cassette.
1
4 Press and playback will start.
5 Adjust the sound using the VOLUME and
DBB controls.
6 For brief interruptions, press
to resume playback.
5
7 By pressing or
is possible in both directions.
8 To stop playback, press 9
➜The keys are automatically released at the
end of the tape.
9 Set the source selector to OFF position
(with the cassette keys released) to switch off
the set.
Note:
– During playback, the keys are automatically
released at the end of a tape and the set is
switched off (unless PAUSE mode
activated.)
– During fast forwarding/rewinding, the keys will
not be released at the end of a tape.To
switch off the set, make sure the cassette
keys are also released.
Cassette recording
General information on cassette
recording
• Recording is permissible insofar as copyright
or other rights of third parties are not
infringed.
• This deck is not suitable for recording on
CHROME (IEC II) or METAL (IEC IV) type
cassettes. For recording you should use
NORMAL type cassettes (IEC I) on which
the tabs have not been broken.
• Check and tighten slack tape before use
with a pencil to avoid jamming the deck
mechanism.
• The recording level is set automatically.
; ;
. Press
6
, fast winding of the tape
/
;
has been
again