Opti-V Installation; Locating The Opti-V; Hardwire Installation - Dimplex VF5452L Owner's Manual

Opti-V Installation

WARNING: ANY INSTAL-
LATION AND SERVICE WORK
CAN ONLY BE PERFORMED BY
QUALIFIED AND AUTHORIZED
PERSONNEL. ALL INSTALLA-
TIONS MUST COMPLY WITH
ALL LOCAL CODES AND BY-
LAWS, AND INSPECTED AND
APPROVED FOR OPERATION
BY LOCAL GOVERNING AU-
THORITY PRIOR TO USE.
WARNING: Construction
and electrical outlet wiring must
comply with local building codes
and other applicable regulations
to reduce the risk of ire, electric
shock and injury to persons.

Locating the Opti-V

The Opti-V uses an illusory relec-
tion technique and is designed
to work best when ambient light
levels are low. If the Opti-V is
installed in brightly lit areas, the
strong relections may diminish
the lame.
Depending on your speciic ap-
plication, installation of the unit
at a height appropriate for the
viewers enjoyment is important. It
is recommended that the follow-
ing guidelines be used for locating
the unit.
6
!
NOTE: Measurements are to
the bottom of the viewing area of
the lame.
For standing applications:
Maximum - 51 in. (129.5 cm)
Minimum - 26 in. (66.0 cm)
For sitting applications:
Maximum - 36 in. (91.4 cm)
Minimum - 26 in. (66.0 cm)

Hardwire Installation

The Opti-V is supplied in an as-
sembled state and is designed to
be permanently installed. The unit
comes ready for hardwire instal-
lation.
WARNING:
to wire your own new outlets or
circuits. To reduce the risk of ire,
electric shock or injury to persons,
always use a licensed electrician.
WARNING:
On/Off switch is set to the Off po-
sition (refer to Operation section)
and that the circuit on which the
Opti-V is to be installed has the
power cut off at the service panel
until installation is complete.
!
NOTE: Please read all instruc-
tions before installing.
1. For rough in framing, the
opening should follow the
Do not attempt
Ensure that the
www.dimplex.com