Storing Destinations; Read-Aloud Function Automatic - Mercedes-Benz COMMAND Operating Instructions Manual

Starting the text reader function man-
ually
To switch to navigation mode: slide 5
X
the controller.
To select Navi: turn and press the control-
X
ler.
The map displays the current vehicle posi-
tion or the navigation menu appears.
If the navigation menu appears, press the
X
controller.
The map shows the vehicle's current posi-
tion.
To show the menu: slide 6 the control-
X
ler.
To select Traffic: turn and press the con-
X
troller.
Select Read Out All Messages on
X
Route.
COMAND reads out the reports in
sequence.
If there are no reports for the route, the
Read Out All Messages on Route
item is gray and cannot be selected.
To cancel the read-aloud function: select
X
Cancel Read-Aloud
COMAND reads out the current report and
then exits the read-aloud function.
Automatic read-aloud function
To switch to navigation mode: slide 5
X
the controller.
To select Navi: turn and press the control-
X
ler.
The map displays the current vehicle posi-
tion or the navigation menu appears.
If the navigation menu appears, press the
X
controller.
The map shows the vehicle's current posi-
tion.
menu
Function.

Storing destinations

To show the menu: slide 6 the control-
X
ler.
To select Traffic: turn and press the con-
X
troller.
Select Read Traffic Announcements
X
Automatically.
Depending on the previous state, switch
the option on O or off ª.
Recalculating the route dynamically
The Dynamic Traffic Route
takes into account all of the traffic reports it
receives for the current route when calculat-
ing the route ( page 60).
Y
If you have selected Dynamic Traffic
Route as the route type, COMAND guides you
to your destination along the updated route.
Storing destinations
General notes
If a route to a destination has been calculated,
COMAND saves the destination to the last
destinations memory. If the memory is full,
COMAND overwrites the oldest destination.
When you save the current vehicle position or
a crosshair position, this position is stored in
the "Last destinations" memory.
You can save destinations permanently in the
address book and on an SD memory card. For
instance, this is possible immediately after
entering an address.
Requirement: the SD memory card is format-
ted using the FAT file system (e.g. FAT32).
95
route type
Z