Raymarine p70 Installation & Operation Instructions page 85

Item Description
Speed Input Select the source for speed data. In
Auto the system will automatically
choose the lowest value between
Speed and SOG Cruise speed allows
you to set a static speed.
Cruise speed Set the cruise speed to the vessel's
typical cruising speed. If no speed
data is available, the SmartPilot
system will use the cruise speed
value you set as a default.
Compass On systems without a GPS then
Offset the compass heading must be
manually aligned to the vessels
known heading.
Latitude If no valid latitude data is available,
Compass the autopilot system will use this
Damping setting which provides the necessary
adaptation for higher latitudes.
Auto release Auto release allows you to override
the pilot by taking hold of the wheel
or tiller. When you release the wheel
or tiller, the pilot will return to the last
locked heading.
Note: Only available on S1, S2,
or S3 course computers only with
drive type set to I/O stern.
Calibration The calibration lock is used to lock
out specific calibration settings
lock
which if changed may require
recommissioning of the autopilot
system. If your system has been
dealer installed then the lock may be
turned on.
Set up menu options
Evolution autopilots
• Hydraulic Pump Type 2 —
ACU-400 only
• Hydraulic Pump Type 3 —
ACU-400 only
• Verado — ACU-200 and
ACU-400
• Auto
• Speed (STW)
• SOG
• Cruise speed
• 0 to 99 Kts
• -10° to 10°
N/A
N/A
• On (default)
• Off
SeaTalk and SPX SmartPilot
Options
N/A
• 0 to 99 Kts
• -179° to 180°
• On
• Off (default)
• Enable (default)
• Disable
• On
• Off (default)
85