Temperature Control; Door Alarm; Light Bulb Change - Electrolux ETB2100 User Manual

TEMPERATURE CONTROL

Set the temperature by using the main temperature
control at slide temperature control of the refrigerator
compartment. When you first turn on the refrigerator, set
both the refrigerator and freezer temperature control to MID.
i TIPS AND INFORMATION
Changing settings
When you change the temperature settings, make
small adjustments and wait 24 hours before assessing
whether you need to make any further changes.
For ETB model.
Refrigerator temperture adjustment
1. Select the refridgerator control.
2. Slide the control to the
right to set Less Cold.
3. Slide the control to the
left to set Colder.
ADJUSTING THE FREEZER TEMPERTURE
1. Select the freezer control.
2. Slide the control to the
left to set Colder.
3. Slide the control to the
right to set Less Cold.
For ETE Model.
Refrigerator temperature adjustment
Press the button
temperature level up or down, 1 being
the lowest is less cold and 5 the highest
is colder. If you keep on pressing the
QUICK
FREEZE
button, the display will return to the first
step. The bar graph level will get lower as
temperature decreases.
Freezer temperature adjustment
1. Select the freezer control.
2. Slide the control to the
left to set Colder.
3. Slide the control to the
right to set Less Cold.
TIPS AND INFORMATION
i
Setting the freezer temperature to the lowest is
not recommended for normal or very hot climate
condition as this will limit the cooling capacity
to other sections of the refrigerator. In very cold
climate, the freezer will need to be set colder.
If the refrigerator door is left open longer than two
minutes, a buzzer will sound. Re-set the alarm by
pressing the Light switch.
REFRIGERATOR
1. Switch off the power at the power
2. Remove shelves and chiller
3. Carefully unclip the light cover by
4. Unscrew the light bulb and replace
COLDER LESS COLD
COLDER LESS COLD
5. Replace the light cover.
6. Replace shelves and chiller compartment.
7. Wait 5 minutes to ensure that pressure in the
FREEZER (Where fitted)
1. Switch off the power at the power point and
to adjust the 2. Carefully unclip the light cover by pulling the
3. Unscrew the light bulb and replace it with a bulb
COLDER LESS COLD
4. Replace the light cover.
5. Wait 5 minutes to ensure that pressure in the
i TIPS AND INFORMATION
Ensure that the
'O' ring is in place
before replacing
the light bulb.

LIGHT BULB CHANGE

point and remove the refrigerator's
power cord from the power point.
compartment.
pulling the top of the cover towards
you.
it with a bulb of the same wattage and
type as the original. If, on removing
the light bulb, a small rubber 'O' ring
comes off with the bulb, fit this 'O'
ring over the new bulb and screw
the bulb back into the socket. See
diagram at bottom of page.
Never insert your finger into the light bulb
socket to check for the presence of the
'O' ring.
refrigeration system is equalised. Then turn on
the refrigerator at the power point.
remove the refrigerator's power cord from the power
point.
top of the cover towards you.
of the same wattage and type as the original. If,
on removing the light bulb, a small rubber 'O' ring
comes off with the bulb, fit this 'O' ring over the new
bulb and screw the bulb back into the socket.
See diagram at bottom of page.
Never insert your finger into the light bulb
socket to check for the presence of the 'O'
ring.
refrigeration system is equalised. Then turn on the
refrigerator at the power point.
Controlling the Temperature

DOOR ALARM

06