Hardware Repair - Philips MCP9360i Service Manual

12. Hardware Repair

This section provides instructions on how to remove and replace modules from the Media-Center.
12.1. Top Cover
12.1.1. Top Cover Removal
WARNING: Disconnect the AC power from the MCP9360i before removing the top cover.
1. At the rear of the chassis remove the 4 torx screws (1). See Figure 12.1-1.
2. Slide the top cover towards the rear, until the locking tabs disengage. See Figure 12.1-2.
3. Lift the top cover straight up and remove it from the chassis.
4. Store the top cover in a safe place.
1
12.1.2. Top Cover Re-Assembly
To re-assemble the top cover, do all steps described in paragraph 12.1.1 in reverse order.
Note: The torque setting required for the top cover screws (1) is 8 kg-cm.
Note: Check the top cover for damage after re-assembly.
1 1
Figure 12.1-1
Hardware Repair
1
MCP9360i 12.
Figure 12.1-2
EN 39