Disassembly - JVC LT-32SH6/A Service Manual

3.1 CAUTION AT DISASSEMBLY:
• Make sure that the power cord is disconnected from the outlet.
• Pay special attention not to break or damage the parts.
• When removing each board, remove the connectors as required. Taking notes of the connecting points (connector numbers) makes
service procedure manageable.
• Make sure that there is no bent or stain on the connectors before inserting, and firmly insert the connectors.
3.2 DISASSEMBLY PROCEDURE [LT-32SH6/A]
3.2.1 REMOVING THE STAND (Fig.1)
(1) Remove the 2 screws [A], then remove the STAND COVER.
(2) Remove the 4 screws [B], then remove the STAND.
3.2.2 REMOVING THE REAR COVER (Fig.1)
• Remove the STAND.
(1) Remove the JACK COVER (L/R).
(2) Remove the 7 screws [C], the 4 screws [D], and the 1 screw [E].
(3) Remove the REAR COVER.
3.2.3 REMOVING THE POWER CORD HOLDER AND SD
CARD BASE (Fig.1)
• Remove the STAND.
• Remove the REAR COVER.
(1) Remove the 2 screws [F], then remove the POWER CORD
HOLDER.
(2) Remove the 1 screw [G], then remove the SD CARD BASE.
3.2.4 REMOVING THE MAIN PWB (Fig.1)
• Remove the STAND.
• Remove the REAR COVER.
(1) Remove the 4 screws [H], then remove the MAIN PWB SHIELD.
(2) Remove the 3 screws [J], then remove the TERMINAL BASE.
(3) Remove the 7 screws [K], then remove the MAIN PWB.
3.2.5 REMOVING THE POWER PWB (Fig.1)
• Remove the STAND.
• Remove the REAR COVER.
(1) Remove the 5 screws [L], then remove the FAN BRACKET.
(2) Remove the 6 screws [M], then remove the POWER PWB.
1-6 (No.YA382)
SECTION 3

DISASSEMBLY

3.2.6 REMOVING THE DVB PWB (Fig.1)
• Remove the STAND.
• Remove the REAR COVER.
(1) Remove the 3 screws [N], then remove the TUNER BASE.
(2) Remove the 1 screw [P] and the 2 screws [Q], then remove
the DVB PWB SHIELD.
(3) Remove the 5 screws [R], then remove the DVB PWB.
3.2.7 REMOVING THE KEY PWB (Fig.1)
• Remove the STAND.
• Remove the REAR COVER.
(1) Remove the 2 screws [S], then remove the KEY PWB.
(2) Remove the 2 screws [T], then remove the CONTROL ASS'Y.