Powering The Transceiver - Audiovox GMRS200W Owner's Manual

Powering the Transceiver

Your GMRS200W radio transceiver operates on a Lithium ion
(Li-ion) battery.
Installing the Batteries:
To install the battery, proceed as follows:
1. Press the release clip lever toward the cover and lift the
battery cover up and off at the same time.
2. Insert the Li-ion battery with the contacts facing down and
touching the unit contacts.
3. Insert the end tab of the battery cover in the bottom slot
and press the top of the cover into position until it clicks into
place.
RELEASE
CLIP LEVER
(TOP OF COVER)
BATTERY
COVER
Charging the Transceiver Battery
CHARGING
LED (RED)
WALL CHARGING ADAPTER
GMRS2WCH
NOTE: The battery will fully charge in approximately 10-12 hours.
WRIST
POSITIVE
BAND
TERMINAL
NEGATIVE
TERMINAL
ADAPTER
PLUG
PTT/CALL
MIC/CHG/SPK
JACK
5
128-6781
5 of 16