Power Window Control Switch - Subaru LEGACY 2004 Service Manual

3. Power Window Control
Switch
A: REMOVAL
1. MAIN SWITCH
1) Disconnect the ground cable from battery.
2) Remove the front door trim. <Ref. to EI-48, RE-
MOVAL, Door Trim.>
3) Disconnect the harness connector.
4) Remove the screws from the reverse side of
front door trim to remove the power window main
switch.
C: INSPECTION
1. MAIN SWITCH
Measure switch resistance.
• LHD model
Driver's seat
• RHD model
Driver's seat
Replace the main switch if faulty.
2. SUB SWITCH
Measure switch resistance.
Passenger's seat and
rear
Replace the sub switch if faulty.

Power Window Control Switch

GW-00259
Switch position
AUTO UP
UP
DOWN
AUTO DOWN
Switch position
AUTO UP
UP
DOWN
AUTO DOWN
Switch position
UP
OFF
DOWN
GW-9
2. SUB SWITCH
1) Disconnect the ground cable from battery.
2) Remove the door trim. <Ref. to EI-48, REMOV-
AL, Door Trim.>
3) Disconnect the connector.
4) Remove the screws from the reverse side of
door trim to remove the power window sub switch.
B: INSTALLATION
1. MAIN SWITCH
Install in the reverse order of removal.
2. SUB SWITCH
Install in the reverse order of removal.
Terminal No.
10 and 2, 7 and 1
10 and 2, 7 and 1
10 and 1, 7 and 2
10 and 1, 7 and 2
Terminal No.
11 and 1, 14 and 2
11 and 1, 14 and 2
11 and 2, 14 and 1
11 and 2, 14 and 1
Terminal No.
2 and 3, 4 and 5
1 and 2, 4 and 5
1 and 2, 3 and 4
GLASS/WINDOWS/MIRRORS
GW-00260
Standard
Less than 1 Ω
Less than 1 Ω
Less than 1 Ω
Less than 1 Ω
Standard
Less than 1 Ω
Less than 1 Ω
Less than 1 Ω
Less than 1 Ω
Standard
Less than 1 Ω
Less than 1 Ω
Less than 1 Ω