Service Position - Sony KLV-V40A10E Service Manual

2-12.SERVICE POSITION

1. Remove the rear cover (See 2-1).
2. Remove the main brackets (See 2-3).
3. Disconnect the harnesses connected to boards beneath the main shield case (NP1, BL and N boards). Remove the main shield case.
4. Remove the NP1, BL and N boards (See 2-7).
5. Remove the A2 board (See 2-6).
6. Place a support of approx 35cm high as close as possible to the TV set as shown below.
7. Arrange the removed circuit boards as shown in the picture. Reconnect the interconnecting harnesses to the circuit boards.
Note: Two new cables are needed to connect the boards in the service position
Cable 1: Part Number: 9-948-020-73
Cable 2: Part Number: 9-948-020-72
G3L board CN6200, CN6201 to NP1 board CN5801, CN5802
N board CN3402 to A2 board CN5105
– 22 –
35cm
AT2X
RM-EA001/RM-ED001