Philips AJ3225 User Manual page 5

RADIO
You can use this set solely as a radio!
1 Adjust RADIO
2 Select your waveband by adjusting the BAND switch.
3 Adjust TUNING to tune to your desired station.
4 Turn the VOLUME control to adjust the volume level.
5 Adjust RADIO
To improve reception:
FM: extend and position the pigtail for optimum reception.
AM: uses a built-in aerial inside the set. Direct the aerial by adjusting the
position of your set.
SETTING THE CLOCK AND ALARM TIMES
The time is displayed using the 24-hour clock
IMPORTANT! To adjust the clock and alarm times accurately, always make sure
you press the
1 Turn the clock control to SET TIME or SET ALARM 1 or SET ALARM 2 to
set the clock or alarm time respectively.
7
or ∞ repeatedly or hold down on the respective button to adjust the
2 Press
hours and minutes.
7
or ∞ when you reach the correct setting.
3 Release
4 After you have set both the hour and minutes, turn the clock control to
CLOCK to run on clock time.
SELECTING THE ALARM MODE
GENERAL
If you wish to use the alarm, you must first set the alarm time first. You can choo-
se from two different alarm modes to wake you up: by radio or buzzer.
• Select your choice of alarm mode by adjusting ALARM 1 or ALARM 2 to RAD
or BUZ.
™ The 2 buzzers are at a set volume and cannot be adjusted. BUZ on
ALARM 1 is a low tone buzzer while BUZ on ALARM 2 is a high tone.
to ON to switch on the radio.
/
OFF ON
to OFF to switch off the radio.
/
OFF ON
7
or ∞ buttons separately and not simultaneously.