Table of Contents
Advertisement
Creating a Baby Profile
1. Enter your baby's name and tap BOY or GIRL to select the gender.
Enter your baby's Birthday, Weight, and Length. This information will serve as the basic data
you can use to track your baby's health information in Baby Tracker.
2. Tap Save.
To edit a Baby Profile later on: Go to Settings > Baby, then select the baby profile and tap
Edit Selected Baby Profile. Once you have edited the baby profile, tap Save.
Pair your Monitor with the Camera
After saving your baby's profile, it is time to set up the camera.
Follow the onscreen instructions.
1. Be sure that the camera is plugged into a working
electrical outlet. The power LED will first illuminate
red; wait a few seconds until the Power LED
illuminates orange, then a few more seconds until
the Power LED is red again. Tap Next.
2. Enter your camera's unique serial number, which is
found on the bottom of the camera. Tap next, then
enter a name for this camera, such as: Nate's Crib
or Playroom. Tap Done.
Now tap Connect. You will see a series of status
messages as the camera and monitor establish the connection.
3. When the "Connection Successful!" message pops up, your new camera is now paired with
your monitor. Video from your new camera will then appear on the screen. The camera's
Power LED illuminates green indicating that it has successfully paired.
If the "Camera could not connect" message appears, follow the onscreen instructions and
try again. If the problem persists, see our troubleshooting section on Page 31.
Getting Started
11
Hide quick links:
Advertisement
Table of Contents
