Operation - NexxTech 6319296 User Manual

BATTERY INSTALLATION
• Remove the battery door located at the back of the main
unit.
• Insert two (2) AA size batteries according to the polarities
shown and replace the battery compartment door.
• When placing the main unit on the table or other
horizontal surface, unfold the table stand for the desired
viewing angle.
PLACEMENT
• Make sure that the main unit is located within the
operating range of all remote sensors.
• Ideally the main unit should be placed within line of sight
of remote sensors. Avoid placing the main unit where
surfaces emitting and radiating heat (e.g. heating ducts
or air conditioners) and areas with interference from
wireless devices (e.g. cordless phones, radio headsets,
baby monitoring devices and other electronics).

OPERATION

Once the main unit is powered, the display will show all
available LCD segments for a moment.
IMPORTANT: All of the display functions will be locked,
to set your local altitude and pressure parameters press
the UP (▲) or DOWN (▼) and SET buttons. The locked
display will show the pressure icon and abbreviation
"inHg" flashing in the Weather/ Pressure Window,
the default time in Clock Window and channel 1's
temperature and humidity readings in Temperature/
Humidity Window.
If pressure and altitude are not configured during this time,
the unit will self-calibrate in a few minutes and show the
default settings for the pressure and altitude (sea level)
and all remote weather sensors readings.
12