Audiovox FRS-1000F Owner's Manual page 10

allows the unit to revert to standby mode. When receiving an incoming
signal, the received signal strength indicator ( ) will display the
relative strength of the signal.
CALL Button (14)
The CALL Button can also be used as a two-way call ringer. Pressing the
button will call another party on the same channel. The Transmit LED will
light red for approximately 3 seconds and then go out.
Up Channel/Volume Button (10)
In the FRS standby mode, pressing this button ( ) will increment the
listening volume. When in function edit mode, this button will be used to
adjust the unit's settings.
Down Channel/Volume Button (10)
In the FRS standby mode, pressing this button ( ) will decrement the
listening volume. When in function edit mode, this button will be used to
adjust the unit's settings.
Mode Button (11)
In the FRS standby mode, pressing this button momentarily will enter the
function edit mode. Subsequent presses will cycle to each mode.
The MODE button is used to select various features for adjustment in both
the FRS and weather modes.
External Speaker (SPK)/Microphone (MIC) Jacks (6)
This set of jacks accepts an Audiovox headset/microphone connector. Refer
to FRS-1000 Operational Modes.
Scan/Lock Mode Button (12)
Press this Button momentarily to enable or disable the scan mode. Press
10