Setup Assistant - Cisco CTS-SX10-K9 Getting Started Manual

Cisco TelePresence SX10 Quick Set
SX10 Quick Set

Setup assistant

When you start the system for the first time, the Setup
assitant runs automatically.
Start the Setup assistant
Navigate to the upper left corner on the home screen and
press OK on the remote control.
Navigate to Settings and press OK. Navigate to
assistant and press OK. Follow the instructions on screen.
If the system does not show a menu on screen:
• Make sure the monitor is connected and has been
switched on.
• Make sure the remote control has batteries installed.
• Make sure the system is switched on.
If the system has just been switched on, wait a few minutes
to allow the system to start up.
If there is still no menu on screen, make sure the monitor
cable is connected to the video output connector. If in doubt,
see the installation guide for your product.
Back to task overview
D15117.01 SX10 Getting Started Guide TC7.1, MAY 2014.
Contents Introduction
Setup
Configuration Configuration
On-screen display
www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved.
8
Getting Started Guide
Appendices Contact