Add Additional Participants To Existing Call; About Video Conferences - Cisco DX70 User Manual

Video Calls

Add Additional Participants to Existing Call

1
In a call tap Add.
3
Place the call, in the usual way. You may alter the
Call settings of that call before you place it—see side
D1510418 User Guide
bar for more.
Cisco TelePresence DX70, DX80
Produced: June 2017 for CE9.0
All contents © 2010–2017
Cisco Systems, Inc. All rights reserved.
2
Locate whom to call, in the usual way.
4
This new call will now be added to the existing
and you have now established a conference.
You may repeat this procedure to the extent
permitted by your video infrastructure.
21
About Video
Conferences
Your video system network may be
equipped with the capability to initiate
a video conference with several
participants.
The maximum number of participants
supported by your video system will
depend on system configuration and
the video infrastructure. If in doubt,
contact your video support team.
If you want to initiate a video
conference, you must call each
participant one by one.
If you are the one who initiated
the conference you will be able to
terminate the entire conference. The
other participants may only disconnect
themselves from the conference.
Call settings. Those you call may
have video systems with different
bandwidths. You are not constrained
to set all participants to a bandwidth
that all systems support. The Call
rate may be set individually for all
participants in order to provide
everyone with the best quality
available for their system. "Change
Call Rate" on page 17.