First Time Setup - Magnavox MRD-250 User Manual

Philips user guide dvd home cinema system mrd-250
Hide thumbs Also See for MRD-250:
Table of Contents

Advertisement

mrd250book 2/14/03 10:49 AM Page 10

10 First Time Setup

Where Do You Start?
Disconnect all equipment from power. Connect equipment to
1
power only after you have finished hooking up everything. Do not
change connections with equipment connected to a power outlet.
2
Put the batteries in the remote control and connect the
AM and FM antennas as detailed below.
Connect the DVD Receiver to a Television using one of the
3
options detailed in your separate Quick-Use Guide (or on
pages 11-13).
You need only one video connection between the DVD Receiver
and the TV. Use Composite Video (good picture quality), S-Video
(better picture), or Component Video (best picture). Use the best
connection available with your TV.
Set the TV to the correct VIDEO IN channel. Such channels
may be called AUX(iliary) IN, AUDIO/VIDEO (A/V) IN, EXT1, S-
VIDEO, etc. These channels are often near channel 00 on your
TV. Or, your TV remote control may have a button or switch that
chooses different Video modes. With some TVs, you use the TV's
menu to select a Video mode. See your TV manual for details.
Connect the speakers and Subwoofer to the DVD Receiver
4
as detailed in your Quick-Use Guide (or on page 14).
Battery Installation
Remove the battery compartment lid by pressing in the tab,
1
then lifting off the lid.
2
Place the batteries in the battery compartment, matching
the +/- markings on the batteries to the +/- markings inside the
remote.
Replace the battery compartment lid.
3
Antenna Connections
Connect the supplied AM loop antenna to the AM jack on
1
the rear of the DVD Receiver.
Reposition the loop antenna to receive the clearest sound for area
stations. Attach the antenna to the base stand if desired.
Connect the supplied FM antenna to the FM jack on the
2
rear of the DVD Receiver. Extend and adjust the antenna until
the clearest station signal is received. For better FM reception, use a
75 ohm coaxial cable (not supplied) to connect the DVD Receiver
to an outdoor FM antenna as shown.
Put the claw
into the slot.
AM
OR
FM
(75 Ω)
Note: If your TV only has a single Antenna
In(put) jack, you will need an accessory RF
Modulator to view the DVD playback on your
TV. See your electronics retailer or contact
Magnavox for details on RF Modulator avail-
ability.
Outdoor FM
Antenna
(not supplied)
75
75
Rear of TV
75
Helpful Hint
• To prevent unwanted noise,
keep the antenna as far away
as possible from the TV, VCR,
or any other radiation source.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents