Display And Operator Control Options In The Main Screen - Siemens SINUMERIK 808D Programming And Operating Manual

Manual machining

3.2 Display and operator control options in the main screen

3.2 Display and operator control options in the main screen
Functionality
Note
If the controller has already been preconfigured to "Manual Machine Plus" by the machine
manufacturer, the operating area "Manual Machine Plus" is activated once the controller has
been started up. If you have not yet executed a reference point approach, you will be in the
operating mode Reference point approach after start-up.
You can reference the axes in the Siemens standard user interface as well as in the
operating area "Manual Machine Plus".
You have referenced the axes and pressed the "Manual" softkey in the "MACHINE"
operating area. The following screen represents the main screen of the "Manual Machine
Plus" operating area.
Figure 3-1
Note about the position display in the main screen for "Manual Machine Plus"
● Absolute position display active:
● Relative position display active (see following diagram):
20
Main screen for "Manual Machine Plus", position display absolute
The position value displayed in the large-size font is the absolute position. No additional
value is shown.
The position value displayed in the large-size font is the relative position. The position
value displayed next to it in the small-size font is the absolute position.
Programming and Operating Manual, 12/2012, 6FC5398-3DP10-0BA0
Manual Machine Plus (Turning)