Samsung SVD-4600 User Manual page 17

Operating Your Camera
Set up the mode using the Function Setup switch.
- SENSITIVITY : You can select up to 8 MD areas.When SENSITIVITY number is high,
motion detection sensitivity is increased to recognize even small movement.
- AREA MODE : Determines whether to use the MD area selected in SENSITIVITY.
- SEL POS : Determines which of the 4 vertices of each MD area is to be used.
- YPOS : Determines the coordinate of the vertical axis for SEL POS.
- XPOS : Determines the coordinate of the horizontal axis for SEL POS.
- FILL SET : Fills in a selected MD area. Fills in a selected MD area. The color of filling is
sequentially selected as brown, orange, blue, cyan, yellowish green, yellow
and red.
- RETURN : Select this to save the MOTION DET menu settings and return to the SPECIAL menu.
Notes
• MD areas show only MOTION DET menu. Therefore, MD areas don't display on the
monitor screen.
• When motion is detected, "MOTION DETECTION" expression is displayed on the screen.
PRIVACY : Hide an area you want to hide on the
screen.
When the SPECIAL menu screen is displayed,
press the Function Setup switch so that the
arrow indicates 'PRIVACY'.
Set up the mode using the Function Setup
switch.
- AREA SEL : You can select up to 8 MD areas.
- AREA MODE : Determines whether to use the area
selected in the AREA SEL, and the size
and position of the area.
- MASK COLOR : Determine area color. You can select Gray, Green, Red, Blue, Black, White.
- TRANSP : Determine the transparency of selected area as controlling number from 0 to 3.
32
COLOR CCD CAMERA User's Manual
- RETURN : Select this to save the PRIVACY menu settings and return to the SPECIAL
menu.
DIS (Digital Image Stabilizer) :
This function mitigates any picture movement due to external factors such as wind.
Notes
• The chance of resolution decrease is existed because DIS function uses the digital zoom.
• DIS doesn't operate when background illumination is too low.
• DIS doesn't operate when object pattern is monotonic as like sky or white wall.
COMM ADJ (Communication Adjustment) :
This function sets up the camera communication status when controlling the
camera through an external control device.
When the SPECIAL menu screen is displayed, press the Function Setup switch
so that the arrow indicates 'COMM ADJ'.
Set up the mode using the Function Setup switch.
- CAM ID : Determines the camera's identification number (between 0 and 255).
- BAUD RATE : You can select 2400/4800/9600/19200/38400/57600 bps.
- UART MODE : You can select NONE, EVEN or ODD for the parity bits.
- RET PKT : Determines whether to send a command back to the controller device
when a communication control command is sent to the camera.
- DISP CAM ID : Display camera title on top left corner of the screen.
* Initial value of communication adjustment
Item Camera ID BAUD RATE UART MODE
Initial value 1 9600 8-NONE-1
COLOR CCD CAMERA
PET PKT
ENABLE
33
User's Manual