Table of Contents
Advertisement
If any fuse (or Fusible Resistor) in this TV receiver is blown, replace it with a
specified one.
When replacing a high wattage resistor (Oxide Metal Film Resistor, over 1W), keep
the resistor 10mm away from PCB.
Keep wires away from high voltage or high temperature parts.
Due to the high vacuum and large surface area of the picture tube, extreme care
should be taken in handling the Picture Tube. Do not lift the Picture Tube by its Neck.
X-RAY Radiation
Warning:
The source of X-RAY RADIATION in this TV receiver is the High Voltage Section and
the Picture Tube.
For continued X-RAY RADIATION protection, the replacement tube must be of the
same type as specified in the Replacement Parts List.
Before returning the receiver to the customer,
Always perform an AC leakage current check on the exposed metallic parts of the
cabinet, such as antennas, terminals, etc., to make sure that the set is safe to
operate without any danger of electrical shock.
4
Advertisement
Table of Contents
