Related Manuals for Pyle PTT25UBT
Summary of Contents for Pyle PTT25UBT
- Page 1 Bluetooth Turntable Player with/ AM/FM Stereo Radio and USB Flash Drive PTT25UBT INSTRUCTION MANUAL www.pyleaudio.com...
-
Page 2: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS: 1. Read the instructions. All uses guidelines, must be read before powering device. 2. Keep the instructions for future use. 3. Attention, use and security guidelines must be respected. 4. The device must not be used near water or be put in contact with moisture. 5. -
Page 3: Battery Installation
BATTERY INSTALLATION The battery compartment is located on the back of the remote control. Remove the battery compartment door by pressing in on the tab and lifting it off. Insert two (2) AAA size batteries (not included) into the battery compartment following the polarity markings inside the battery compartment. -
Page 4: Location Of Controls
LOCATION OF CONTROLS 1) Record Button 2) Repeat/Random button 3) Radio Band Selector 4) Loud speaker 5) USB Socket 6) Dial scale 7) Function knob 8) FM Stereo LED Indicator 9) Remote sensor 10) Skip Up Down Button 11) Play/Pause/Stop Button 12) +10 Button 13) Record LED indicator... - Page 5 Hints for best reception:- The receiver has a built-in bar antenna. If AM reception is weak. Slightly rotate or re-positioning of the unit AM : will usually improve the AM reception. The receiver has a built-in FM Wire Antenna (26) hanging at the rear cabinet. This wire should be totally FM : unraveled and extended for best reception.
- Page 6 Select the Main Function selector (7) to “ BT ” mode. The Bluetooth LED indicator (16) will be flashing, this means the Bluetooth not connected yet / searching mode. Switch on the Bluetooth feature of your Bluetooth device (such as mobile phone) and select “PTT25UBT” Bluetooth equipment to connect.
- Page 7 Encoding of Phono into MP3 file The system is able to encode the Phono to MP3 format and recording at memory media with USB connected port (support maximum up to 2GB memory size). A) Phono encoding Set the Function knob (7) to “Phono/Aux” made and then press “ Rec” Button(1). The Record LED indicator (13) will light up.
- Page 8 Removing of USB To remove the USB, turn off the power or switch the function mode to either Phono or Tuner first. For USB port -- unplug it by pulling out the USB socket directly. Line out connection You can connect the system to your whole Hi-Fi system by connecting the Line out Socket (25) to the auxiliary input socket with a RCA cable (not included).