Something Not Working - John Lewis JLWM 1406 Instruction Manual

Something not working

Please carry out the following checks before contacting your local Service Force agent.
IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by
incorrect use or installation, a charge will be made even if the appliance is under guarantee.
During machine operation it is possible that the red pilot light of the button
alarm codes appears on the display and some acoustic signals sound to indicate that the machine is not
working:
E10
- : problem with the water supply
- E20 : problem with water draining
E40
- : door open
- EF0 Anti-flooding system has activated
:
Once the problem has been eliminated, press the button
problem persists, contact your local Service Force Centre.
Symptom
The machine does not start
The machine does not fill
The machine fills then empties
immediately
The machine does not empty
and/or does not spin
There is water on the floor
Unsatisfactory washing results
10
to restart the programme. If after all checks, the
Solution
●
The door has not been closed. (
●
The plug is not properly inserted in the power socket.
●
There is no supply at the socket.
●
The main fuse or the fuse in the plug has blown.
10
●
The button has not been pressed.
● The Delay start option has been selected.
●
The Child lock option has been enabled.
●
The water tap is closed. (
●
The filter in the inlet hose is blocked. (
●
The inlet hose may be squashed or kinked. (
●
The door has not been closed. (
●
The end of the drain hose is too low.
●
The end of the drain hose is submerged in water.
●
There is no vent in the end of the drain hose.
●
The drain hose may be squashed or kinked. (
●
The Rinse Hold or Quiet option has been selected.
●
The drain pump may be blocked. (
●
The No Spin option has been selected
●
The drainage system pipes are blocked.
●
Too much detergent or unsuitable detergent has been used (creates
too much foam).
●
Check whether there are any leaks from the inlet hose fittings. It is not
always easy to see this as the water runs down the hose; check to see
if it is damp.
●
The inlet or drain hose may be damaged or not securely positioned.
● The cap on the emergency emptying hose has not been replaced after
cleaning the filter.
●
Too little detergent or unsuitable detergent has been used. An
insufficient amount of detergent leaves the laundry looking grey and
causes lime scale to form.
●
Stubborn stains have not been treated prior to washing
●
The correct wash programme/temperature has not been selected.
●
Too much laundry has been placed in the drum.
19
10
flashes, one of the following
E40 )
E10
)
E10
)
E10
)
E40
)
E20
)
E20
)