Table of Contents
Advertisement
6.
The image below shows the glass with its resistance. The detail shows a portion of the resistance that
covers entirely the underside of the glass.
Figure 4-67
7.
After replacing the glass and resistance assembly, you must regulate four points on the printing plate.
Imagining a 20 cm square positioned at the centre of the table, the four corners are the points at which
Extruder 1 is at a distance of 0.08 mm from the glass. Verify also the adjustment of Extruder 2. The figure
below shows the ideal positions and the corners of the square.
Figure 4-68
4-40
Service Manual
Portion of resistance
Y118040-3
Advertisement
Table of Contents
