Maytag DWU8750AAE User Manual page 10

Options:
the number of hours you would like the Pots &
Pans cycle delayed. Delay Start ean be eaneelled
Temp Boost Sensor:
by advancing the dial to any cycle.
If for any reason the incoming water To Start Dishwasher:
temperature is below 120°F, press the On
button to assure the water is heated to proper After loading set the dial to the desired cycle.
temperature for best cleaning and drying Press button for desired options.
results. The dial ,Mll pause at the _ to extend
the main wash and the Heating Delay light will NOTE: Run the water from the hot water tap to
clear the line of cold water before
turn on.
sta_ing.
Press the Offbutton to cancel the Temp Boost
Sensor. Press the door until it latches. The cycle will
begin with a drain prior to fill and the On
Heated Rinse and Dry Options: indicator will light.
RINSE TEMP Indicator Lights:
Press the Sani button te turn the heating
element on during "allrinses. The Sani option When Delay Start is selected the Delay Start
helps maintain water temperature and improve light glows until the cycle begins. The On light
drying results, indicates that the dishwasher is operating. At
Press the Normal button if Sani is not desired, the end of the dry phase Clean will remain lit
until the dial has been advanced to the _1. The
The beating element will be off in all rinses.
Heating Delay light indicates that the main
FAN DRY wash is being extended to heat the water to
Press the Iteat button to turn the heating proper temperature.
element on during the fan drs' period. This
option prox4desfaster drying_ Adding a Forgotten Item:
Press the Air button to turn the beating element For best cleaning, the forgotten item should be
off during the fan dry period, added early in the cycle.
NOTE: Temp Boost Sensor, Rinse Temp and 1. Unlatch the door and wait until the sound of
Fan Dry options can be used separately eirculating water stops.
or together.
2. Open the door and add the item.
Delay Start:
3. Pause before latching the door. The cycle will
You can delay the start of the Pots & Pans cycle continue at the point it was interrupted.
up to six hours. To set up a delay, tm'n the dial to
PAGE 9