Stihl MS 460 Instruction Manual page 53

English / USA
: Coat rope rotor bearing bore with
non-resinous oil – Slip rotor over
starter post – turn it back and forth
to engage anchor loop of rewind
spring.
2
3
4
: Refit the pawls (4) in the rotor.
: Fit the washer (3) on the starter
post.
: Use screwdriver or suitable pliers to
install spring clip (2) on starter post
and engage it on the pawls – the
spring clip must point clockwise –
see illustration.
52
Tensioning rewind spring
4
: Make a loop in the unwound starter
rope and use it to turn the rope rotor
six full revolutions in the direction of
the arrow
: Hold the rotor steady – pull out and
straighten the twisted rope
: Release the rope rotor – let go of
rope slowly so that it winds onto the
rotor.
The starter grip must locate firmly in the
rope guide bush. If the grip droops to
one side: Add one more turn on rope
rotor to increase spring tension.
When starter rope is fully extended it
must still be possible to rotate the rotor
at least another half turn. If this is not the
case, the spring is overtensioned and
could break. Take one turn of rope off the
rotor.
: Fit the fan housing on the
crankcase.
Rescue Saw