Install The Camera In The Housing; Install The Wall Bracket; Install The Camera On The Bracket - Axis Q1921 Installation Manual

Axis Thermal Camera Accessories and Spare Parts Installation Guide

Install the camera in the housing

1. Remove the upper holder, see illustration on page 7.
2. Secure the camera and upper holder with the camera screw and washer.
3. Fit the upper holder on the lower holder and adjust the distance between holders according to
the table in Adjust the holder distance, on page 9.
4. Tighten the screws to 2 Nm. Be careful not to overtighten the screws.
5. Connect the window heater cable to the window heater connector on the camera, see
illustrations on page 6 and page 7.
6. Optionally insert an SD memory card (not included) into the SDHC (Secure Digital High
Capacity) card slot. A standard or high capacity SD card is required to store images locally in
the camera.

Install the wall bracket

1. Use the supplied drill template to prepare a wall for installation of the wall bracket.
2. Route the network cable through the wall bracket according to the wall bracket illustration on
page 6. Leave approximately 30 cm (11.8") of cable for connecting the camera.
3. Install the wall bracket on a wall and make sure that the screws and plugs are appropriate for
the material (e.g. wood, metal, sheet rock, stone).

Install the camera on the bracket

1. Loosen the cable cover screws and remove the cable cover from the bottom cover.
2. Install the camera with the bottom cover on the bracket and tighten the bracket adapter
screws.
3. Remove the gasket from one of the cable holes in the bottom cover.
4. Route the cable through the hole and attach the cable gasket to the hole.
Bracket screw (4x)
Bracket adjustment screw
Network cable (route
through wall bracket)
Cable holes with gaskets
Bottom cover
Cable cover
Cable cover screw (2x)
Wall bracket
Page 11