Table of Contents
Advertisement
SECTION 7 –
PLUMBING
2. Press ON/OFF button, set water temperature
to WARM, then press START. Let machine
fill until the drum turns (this could take up to
1 to 2 minutes).
3. Press ON/OFF button to turn power OFF.
4. Advance Cycle Selector to "B".
5. Press ON/OFF button, then press START.
6. After letting antifreeze drain completely from
drum, press the ON/OFF button to turn power
OFF. Finished.
To use Washer/Dryer again after seasonal
storage:
1. Reconnect water inlet hoses to corresponding
HOT/COLD faucets. Turn faucets ON.
NOTE: Check water inlet hoses and pump
periodically (see manufacturer's user
guide for further information).
2. Plug Washer/Dryer into electrical outlet (or
reconnect power).
3. With Washer/Dryer power OFF, pour 1/2
TBSP. of powder detergent (or liquid
equivalent) into "Compartment 2" inside
Dispenser Drawer.
4. Advance Cycle Selector to "Position 4".
5. Press ON/OFF button, then press START.
6. Allow machine to run through the complete
cycle to clean out any remaining antifreeze.
Finished.
Winterizing Dishwasher
–If Equipped
Follow manufacturer's instructions provided
in your InfoCase for operating and for
interrupting cycles.
1. Empty all dishes from the Dishwasher.
2. Follow coach winterization instructions for
using the winterization valve to draw RV
water system antifreeze into the water system
so antifreeze can enter the Dishwasher.
3. Set the Dishwasher controls to the start of the
Rinse cycle and run briefly until antifreeze
can be seen inside the dishwasher.
7-20
4. Set the controls to the end of the Rinse cycle
to pump the liquid out of the Dishwasher to
make sure the lines and pump contain
antifreeze.
5. Turn Dishwasher controls to OFF.
6. Pour approximately one quart of RV water
system antifreeze directly into the
Dishwasher to ensure protection of pump and
drain lines.
7. Dishwasher is now winterized.
To use Dishwasher again after seasonal
storage:
1. Flush antifreeze from the waterlines (if
antifreeze fill winterization procedure was
performed).
2. Set the Dishwasher controls to the start of the
Rinse cycle and run briefly until antifreeze
can be seen inside the dishwasher.
3. Set the controls to the end of the Rinse cycle
and allow the machine to run through the
complete cycle to clean out any remaining
antifreeze.
Advertisement
Table of Contents
