Names Of Each Part - Hitachi CP-X600 Service Manual

3. Names of each part

Projector
(1) Speakers (x 2)
(2) Focus ring
(3) Zoom ring
(4) Lamp cover
The lamp unit is inside.
(5) Front cover
(6) Lens
(7) Lens cover
(8) Remote sensors (x 3)
(9) Elevator feet (x 2)
(10) Elevator knobs (x 2)
(11) Filter cover
The air fi lter and intake vent are
inside.
(12) Exhaust vents
(13) Intake vents
(14) Rivet hole
(15) Handle
(16) Control panel
(17) Rear panel
WARNING ►HOT! : Do not touch around the lamp cover and the exhaust
vents during use or just after use, since it is too hot.
►Do not look into the lens or vents while the lamp is on, since the strong light
is not good for your eyes.
►Do not grab the front cover to hold the projector up, since the projector may
drop down.
►Do not handle the elevator knobs without holding the projector, since the
projector may drop down.
CAUTION ►Maintain normal ventilation to prevent the projector from
heating up. Do not cover, block or plug up the vents. Do not place anything that
can stick or be sucked to the vents, around the intake vents. Clean the air fi lter
periodically.
CP-X600(EDX40K3)
HOT!
(3)
(2)
(5)
(12)
HOT!
(9)
(7)
(13)
(16)
(8)
(1)
(17)
3
(4)
(16)
(6) (8)
(10)
(9)
(9)
(1)
(8)
(11)
(14)
(9)
(10)
(15)