Powermatic 4224B Operating Instructions Manual page 7

Fig 3
Remove the stop pin (B) to slide the headstock off the bed.
Carefully turn bed upside down on skid. Make sure nothing
is beneath that would scratch the bed ways. Prevent
damage to the POWERMATIC-Logo plate.
Attach the leg stand with 8 hex socket cap screws, lock
washers and flat washers (A, Fig 4-1).
Fig 4-1
Install levelling feet and tighten nuts against the leg
(Fig 4-2).
Fig 4-2
Turn bed upside down.
Adjust the feet so that the lathe rests evenly on the floor.
Reinstall headstock, tool rest and tailstock.
Note:
If installing the 508mm bed extension (#6294727, optional)
to the leg, the right leg and bed end surfaces must be
flush.
Tool caddy assembly:
Mount the tool caddy with two screws and lock washers to
the left leg (Fig 5)
Fig 5
Note:
The tailstock body can also be used to store tools (Fig 6).
Fig 6
Stand shelf:
You can install an extra shelf that rests between the legs if
you wish.
There are different possibilities (see Fig 7-1 to 7-3).
Fig 7-1