5. Insert the paper clips, etc. into the Tray as below figure,
lift up the lever using the Eject Pin while pushing the dot-
ted point of the Tray.
10.2.3. Pulley Gear, Belt
1. Perform the step "10. 2. 2. Tray".
2. Push the Post to the direction of arrow by using the slot-
ted screwdriver.
3. Remove the Pulley Gear and Belt.
10.2.4. Slide Cam
1. Perform the step "10. 2. 3. Pulley Gear, Belt".
2. Remove the Sheet.
3. Disconnect the 3 FFCs.
4. Remove the 2 Screws (B) and the Angle.
5. Remove the Drive P.C.B..
Caution:
Though the Drive P.C.B. is not supplied as replace-
ment parts, it must be removed for after disassem-
bling.
6. Open the connector lock, and disconnect the FFC.
7. Remove the 2 Screws (C), and remove the Traverse
Base Ass'y with spreading the 2 hooks to the direction of
arrows.
31