Table of Contents
Advertisement
Features
Network Connections
Ethernet and Token Ring Support
Remote Management
Modular, Easy-to-Use Design
Standards-Based Compatibility
HP AdvanceStack 100VG Hub-7E
At A Glance
The HP J3137A AdvanceStack 100VG Hub-7E is a high-speed multiport
repeater. With this hub, you can connect computers and other devices to-
gether in an unshielded twisted-pair cable network. This hub can be used to
upgrade your 10 Mbit/s Ethernet/IEEE 802.3 network that uses unshielded
twisted-pair cables to a 100 Mbit/s network.
Throughout this manual, this hub will be called the Hub-7E. The following
illustration shows the Hub-7E.
Hub status LEDs
Six RJ-45 (twisted-pair) ports to connect to end nodes or other devices.
An Uplink port to cascade to another 100VG hub such as the following hubs:
HP J2413A AdvanceStack 100VG Hub-7M
HP J2410A AdvanceStack 100VG Hub-15
HP J2415A AdvanceStack 100VG Hub-14
Support for both Ethernet and Token Ring framing. If you have 100VG LAN
adapters with 100VG Token Ring drivers, you can select the Token Ring position.
An RS-232 port to connect an ASCII console for monitoring and troubleshooting
the hub and network.
LEDs showing power, activity, cascade, fault, and port status provide quick,
easy-to-read hub status information and troubleshooting assistance.
A small footprint that allows you to install the hub in a variety of ways, including
on a desk, under a desk, or on a wall.
Compatible with the IEEE 802.12 standard.
twisted-pair port LEDs
Uplink port for
Twisted-pair
hub to hub
ports
connections
At A Glance
Frame switch
1
Advertisement
Table of Contents
