La Crosse Technology WS9132 Instruction Manual page 6

3. After the batteries are inserted, the Weather Station will start receiving data signal
from the transmitter.
4. If the optional probe has been plugged to the dual channel transmitter, the outdoor
temperature should then be displayed on the Weather Station on channel 1 and 2.
Also, the signal reception icon will be displayed. If this does not happen after 2
minutes, the batteries will need to be removed from both units and reset from step 1.
Note:
Channel 1 will show the reading from the internal sensor of the dual channel transmitter;
Channel 2 will show the reading sensed by the probe. If the probe is not plugged to the
transmitter, " - -" will be shown on Channel 2.
5. In order to ensure sufficient 868 MHz transmission, the final position between the
Weather Station and the transmitter should not be more than 100 meters (see notes
on "Positioning" and "868 MHz Reception").
6. Once the remote temperature has been received and displayed on the Weather
Station, the DCF time code reception is automatically started. This takes typically
between 3-5 minutes in good conditions—but may take up to 4 nights.
When two transmitters are used
1. User shall remove all the batteries from the Weather Station and transmitters and wait
60 seconds (if setting has been done with one transmitter before).
2. Insert the batteries into the first transmitter.
51