Advertisement
Quick Links
Installation And Testing Guide
Quick Reference Install Guide
1
Write the VIN (Vehicle Identification Number) on the mirror
hanger/activation card included with this system.
Choose a discreet yet ideal location for the module (the large
2
white label must face towards the sky because the GPS and cel-
lular antennas are built in.
Route wiring and make all necessary wiring connections and
3
apply power to the module - SEE THE WIRING DIAGRAM IN THIS
BOOKLET.
4
Move the vehicle outside so the module has a clear view of the
sky and leave the vehicle's ignition in ON/RUN position.
After approximately 3 minutes, check the indicator lights to make
5
sure the unit has cellular service and has a GPS lock. Both the yel-
low and orange lights should be on solid.
Call the Omega GPS operation center at 800-307-0680 to perform
6
the installation test. Be sure to have the serial number and VIN
available.
7
Complete the installation by reassembling the vehicle's interior.
IMPORTANT:
8
or give it to the vehicle's owner. The device cannot be activated
without this information
IM_GPS-D4500 r1 9/30/09
VEHICLE TRACKING & RECOVERY SYSTEM
Be sure to hang the mirror hanger/activation card
Detailed instructions cont'd on following pages ->
GPS-D4500
Model:
Advertisement
Summary of Contents for Omega GPS-D4500
- Page 1 GPS lock. Both the yel- low and orange lights should be on solid. Call the Omega GPS operation center at 800-307-0680 to perform the installation test. Be sure to have the serial number and VIN available.
-
Page 2: Step 3: Wiring Connections
Step 1: Record Vehicle Info On Activation Card The activation card is the bottom part of the mirror hanger included with this system. It should already have a sticker with the serial number on it. Be sure this serial number matches the serial number on the device being installed. This will prevent unnecessary troubles later during the testing process. - Page 3 existing bolt in the vehicle and securely ground the wire. BLUE and RED Starer Interrupt wires (from relay socket; optional): These wires are used the interrupt the vehicle’s starter circuit in a vehicle theft scenario. Locate the vehicle’s starter wire (typically found in the ignition switch harness). It will show +12V when the ignition key is turned to the START position. Cut the starter wire and connect the BLUE and RED wires to each side of the cut wire.
-
Page 4: Step 8: Complete The Installation
Step 5: Apply power to the device You can now plug the molex connector/wiring harness into the module and insert the 3 amp fuse into the RED power wire. Also, be sure the ignition key is in the ON/RUN position (this puts the device in full power mode to ensure con- nectivity). Step 6: Check the indicator lights Locate the indicator lights on the end of the module. They are next to the main connector. -
Page 6: Useful Information
Useful Information OmegaGPS Activation Phone Number: 800-307-0680 Login Website: www.OmegaGPS.com Omega Research & Development, Inc. Corporate Website: www.CarAlarm.com Corporate Phone: 800-554-4053 Install Tech Support (hardwire/wiring only): 800-921-TECH (8324) Service Tech Support: 800-307-0680... - Page 7 BLANK PAGE IM_GPS-D4500 r1 9/30/09...
- Page 8 BE SURE THAT THIS ACTIVATION CARD IS GIVEN TO THE VEHICLE OWNER. THEY CANNOT ACTIVATE THEIR SERVICE WITHOUT THIS INFORMATION BE SURE TO FILL OUT ALL THE INFORMATION ON THE BACK OF THE CARD (see the example to the right). IT HELPS THE Unlock Doors VEHICLE OWNER UNDERSTAND WHAT...