Related Manuals for Philips 32PFL3605H/12
Summary of Contents for Philips 32PFL3605H/12
- Page 1 Register your product and get support at www.philips.com/welcome User Manual 32PFL3605H/12 42PFL3605H/12 47PFL3605H/12...
- Page 2 0800 261 3302 United Kingdom General No: 0800 331 6015 General National Rate No: 0870 911 0036 Україна 0-800-500-697 This information is correct at the time of press. For updated information, see www.philips.com/support. Model Serial www.philips.com/support Lokalni poziv Bezplatný hovor Lokalt opkald kohalik kõne tariifi...
-
Page 3: Table Of Contents
Rearrange channels Test digital reception 7 Connect devices Back connector Side connector Connect a computer Use a Conditional Access Module Use Philips EasyLink Use a Kensington lock 8 Product information Supported display resolutions Multimedia Tuner / Reception / Transmission Remote control... -
Page 4: Notice
One of Philips’ leading Business Principles is to take all necessary health and safety measures for our products, to comply with all applicable legal requirements and to stay well within the EMF standards applicable at the time of producing the products. - Page 5 Mains fuse (UK only) This TV is fitted with an approved moulded plug. Should it become necessary to replace the mains fuse, this must be replaced with a fuse of the same value as indicated on the plug (example 10A). Remove fuse cover and fuse.
-
Page 6: Important
TV. If liquids are spilt on or into the TV, disconnect the TV from the power outlet immediately. Contact Philips Consumer Care to have the TV checked before use. • Never place the TV, remote control or batteries near naked flames or other heat... - Page 7 • When you disconnect the power cord, always pull the plug, never the cable. • Disconnect the TV from the power outlet and antenna before lightning storms. During lightning storms, never touch any part of the TV, power cord or antenna cable.
-
Page 8: Environmental Efforts
flower– www.ecolabel.eu You can find detailed information on standby energy consumption, warranty policy, spare parts and recycling of this TV on the Philips website for your country at www.philips.com. This TV has features that contribute to energy-efficient use. This TV was awarded the European Ecolabel for its environmental qualities. -
Page 9: Your Tv
3 Your TV Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your TV at www.philips.com/welcome. This section gives you an overview of commonly used TV controls and functions. Side controls and indicators +/-: Increases or decreases volume. - Page 10 (Standby-On) • Switches the TV to standby if it is on. • Switches on the TV if it is in standby. MENU Toggles the main menu on or off. c MHEG/TELETEXT Toggles teletext on or off. SOURCE Selects connected devices. e Colour buttons Selects tasks or options.
-
Page 11: Use Your Tv
4 Use your TV This section helps you perform basic TV operations. Switch your TV on / off or to standby To switch on • If the standby indicator is off, press (Power) at the side of the TV. • If the standby indicator is red, press (Standby-On) on the remote control. -
Page 12: Watch Connected Devices
Watch connected devices Note • Switch on the device before selecting it as a source on the TV. Use the source button Press SOURCE. » The source list appears. Press to select a device. Press OK to confirm your choice. »... -
Page 13: Use More Of Your Tv
5 Use more of your TV Access TV menus Menus help you to install channels, change picture and sound settings and access other features. Press MENU. » The menu screen appears. Add new device Watch TV Press to select and navigate through one of the following menus. -
Page 14: Change Picture And Sound Settings
Change picture and sound settings Change picture and sound settings to suit your preferences. You can apply pre-defined settings or change settings manually. Note • When watching TV or using external devices, press OPTIONS then select [Picture and sound] for quick access to picture and sound settings. - Page 15 • [Dynamic backlight]: Adjusts brightness of the TV backlight to match lighting conditions. • [MPEG artifact reduction]: Smoothes out transitions on digital pictures. You can switch this feature on or off. • [Colour enhancement]: Makes colours more vivid and improves the details in bright colours.
- Page 16 Use smart sound Use smart sound to apply pre-defined sound settings. Press SOUND. » [Smart sound] menu appears. Press to select the following settings. • [Custom]: Applies the settings that were customised in the sound menu. • [Standard]: Adjusts sound settings to suit most environments and types of audio.
-
Page 17: Use The Universal Access Menu
Use the universal access menu You can activate the universal access menu during the first installation. Once enabled, you can quickly access the visually impaired and hearing impaired menus when watching TV or external devices. • You can also enable the universal access menu by selecting [Setup] >... -
Page 18: Create And Use List Of Favourite Channels
Select T.O.P. teletext broadcasts Table Of Pages (T.O.P.) teletext broadcasts allow you to jump from one subject to another without using page numbers. T.O.P. teletext is not broadcast on all TV channels. Press MHEG/TELETEXT. » The teletext screen appears. Press INFO. -
Page 19: Use The Electronic Programme Guide
Add a channel to a favourite list • View all channels before adding a channel to a favourite list. When watching TV, press OK. » The channel grid appears. Press to select a channel to add to a favourite list. Press OPTIONS. -
Page 20: Use The Tv Clock
Use the EPG options menu Use the EPG options menu to set or clear reminders, change day and access other useful EPG options. Press GUIDE. Press OPTIONS. » The EPG menu appears. Press to select one of the following options. •... -
Page 21: Use Timers
Change the clock mode Press MENU. Press to select [Setup] > [Installation] > [Clock] > [Auto clock mode]. Press to select [Automatic] or [Manual]. Press OK to confirm. Change the time zone Press MENU. Press to select [Setup] > [Installation] > [Clock] > [Time zone]. Press to select your time zone. -
Page 22: Use Tv Locks
Automatically switch the TV on (on timer) You can switch on the TV from standby to a specific channel at a specified time. Press MENU. Press to select [Setup] > [Features] > [On timer]. Press to enter the [On timer] menu. •... -
Page 23: Use Subtitles
Note • You have to enter your code every time you turn on your TV. • Switch the TV off and on again for the change to take effect. Lock or unlock one or more channels When watching TV, press OK to display the channel grid. -
Page 24: View Photos And Play Music From A Usb Storage Device
USB storage device Caution • Philips is not responsible if the USB storage device is not supported, nor is it responsible for damage or loss of data from the device. Use the USB connector to view photos or listen to music stored on a USB storage device. -
Page 25: Music Settings
View a slide show of your photos When a full screen image of a photo is displayed, press OK. » A slide show begins from the selected photo. Press the following buttons to control the slide show: • OK to pause the slide show. •... -
Page 26: Listen To Digital Radio Channels
[Select list] > [All] to exit radio channels and view all channels. Update the TV software Philips continuously tries to improve its products and we recommend that you update the TV software when updates are available. Check www.philips.com/support for availability. -
Page 27: Change Tv Preferences
Update using OAD If using (DVB-T) digital broadcast, your TV automatically receives software updates. If you receive a message on your screen asking you to update your software: • Select [Update now] to update the software immediately. • Select [Remind me later] to exit the update screen at that time and be reminded later. -
Page 28: Access Decoder Channel
Access decoder channel You can map channels provided through a decoder or descrambler to your TV channel selection. In this way, you can select these channels by using the RC of your TV. The decoder or a descrambler must be connected to EXT1 (SCART). -
Page 29: Install Channels
6 Install channels The first time you set up your TV, you are prompted to select a menu language and to install TV and digital radio channels (if available). This chapter provides instructions on how to re-install and fine tune channels. Automatically install channels This section describes how to search and store channels automatically. -
Page 30: Manually Install Channels
Manually install channels This section describes how to search and store analogue TV channels manually. Step 1 Select your system Note • Skip this step if your system settings are correct. Press MENU. Press to select [Setup] > [Installation] > [Channel installation] >... -
Page 31: Rename Channels
Rename channels You can rename channels. The name appears when you select the channel. When watching TV, press OK to display the channel grid. Select the channel to rename. Press OPTIONS. » The channel options menu appears. Press to select [Rename channel], then press OK. -
Page 32: Connect Devices
7 Connect devices This section describes how to connect devices with different connectors. Examples are provided in the Quick Start. Note • You can use different types of connectors to connect a device to your TV. Back connector a TV ANTENNA Signal input from an antenna, cable or satellite. - Page 33 d SERV. U For use by service personnel only. e PC IN (VGA and AUDIO IN) Audio and video input from a computer. AUDIO IN LEFT/RIGHT VGA/DVI f HDMI 1 Digital audio and video input from high- definition digital devices such as Blu-ray players.
-
Page 34: Side Connector
Side connector a AUDIO L/R Audio input from analogue devices connected to VIDEO. b VIDEO Composite video input from analogue devices such as VCRs. c USB Data input from USB storage devices. d HDMI Digital audio and video input from high- definition digital devices such as Blu-ray players. -
Page 35: Connect A Computer
(Headphone) Stereo audio output to headphones or earphones. f COMMON INTERFACE Slot for a Conditional Access Module (CAM). Connect a computer Before you connect a computer to the TV • Set the screen refresh rate on your computer to 60Hz. •... -
Page 36: Use A Conditional Access Module
• This menu option is available only if the CAM is inserted and activated correctly. Use Philips EasyLink Your TV supports Philips EasyLink, which uses the HDMI CEC (Consumer Electronics Control) protocol. EasyLink-compliant devices that are connected through HDMI connectors can be controlled by a single remote control. -
Page 37: Use A Kensington Lock
TV. You can use the remote control from the connected device to adjust the volume. Enable or disable EasyLink Note • Do not enable Philips EasyLink if you do not intend to use it. Press MENU. Press to select [Setup] >... -
Page 38: Product Information
8 Product information Product information is subject to change without notice. For detailed product information, go to www.philips.com/support. Supported display resolutions Computer formats • Resolution - refresh rate: • 640 x 480 - 60Hz • 800 x 600 - 60Hz •... -
Page 39: Supported Tv Mounts
Supported TV mounts To mount the TV, purchase a Philips TV mount or a VESA-compatible TV mount. To prevent damage to cables and connectors, be sure to leave a clearance of at least 2.2 inches or 5.5cm from the back of the TV. -
Page 40: Troubleshooting
Disconnect the power cable from the power outlet. Wait until the TV cools down before reconnecting the power cable. If the blinking reoccurs, contact Philips Consumer Care. You forgot the code to unlock the TV lock feature • Enter ‘8888’. -
Page 41: Picture Issues
Picture issues The TV is on, but there is no picture: • Check that the antenna is properly connected to the TV. • Check that the correct device is selected as the TV source. There is sound but no picture: •... -
Page 42: Computer Connection Issues
If you cannot resolve your problem, refer to the FAQs for this product at www.philips.com/support. If the problem remains unresolved, contact Philips Consumer Care in your country as listed in the Addendum. Warning • Do not attempt to repair the product yourself. -
Page 43: Index
10 Index analogue fine-tune antenna back connectors batteries bracket for wall mount care channel decoder channel grid channels favourites list fine-tune grid install automatic manual list lock rename reorder / rearrange switch test reception (digital channels) troubleshooting tune update child lock lock channels lock connected devices PIN code... - Page 44 digital services teletext disconnect USB display resolution dispose EasyLink disable enable one-touch play one-touch standby system audio control eco-green end of life energy efficiency environmental care e-sticker factory settings favourites list add to list create list view list fine-tune channels green HDMI hearing impaired...
- Page 45 connect resolution picture format change troubleshooting picture settings PIN code pixel plus link power power consumption preferences product specifications radio rearrange channels reception recycle register product remote control batteries overview technical specifications rename channels reorder channels resolution restore default safety screen care settings picture...
- Page 46 view photos video format technical specifications volume adjust automatic levelling delta mute wall mount 10, 34 4, 37...
- Page 49 © 2010 Koninklijke Philips Electronics N.V. All rights reserved.