Motorola RDX Series User Manual page 58

3. Plug one side of the cloning cable mini USB
connector to the first SUC and the other end to
the second SUC.
Note: During the cloning process, no power is
being applied to the SUC. The batteries will
not be charged. Only data communication is
being established between the two radios.
4. Turn ON the Target Radio and place it into one
of the SUCs.
5. For the Source Radio, power ON the radio with
the following sequence:
• Long press the PTT button and SB2
simultaneously while turning the radio ON.
• Wait for 3 s before releasing the buttons until a
distinctive audible tone is heard.
6. Place the Source radio in its SUC, press and
release SB1.
7. After cloning is completed, the Source radio will
sound either a 'pass' tone (cloning was
successful) or a 'fail' tone (cloning process has
failed). The 'pass' tone sounds like a good key
'chirp' whereas the 'fail' tone sounds similar to a
'bonk' tone. If the Source radio is a display
model, it will either show 'Pass' or 'Fail' on the
display (a tone will be heard within 5 seconds).
8. Once you have completed the cloning process,
turn the radios OFF and ON to exit 'clone'
mode.
What To Do If Cloning Fails
The radio will emit an audible "bonk" indicating that
the cloning process has failed. In the event that the
cloning fails, perform each of the following steps
before attempting to start cloning process again:
1. Ensure that the batteries on both radios are fully
charged.
2. Check the cloning cable connection on both
SUCs.
3. Ensure that the battery is engaged properly on
the radio.
4. Ensure that there is no debris in the charging
tray or on the radio contacts.
5. Ensure that the Target radio is turned ON.
6. Ensure that the Source radio is in cloning mode.
55
English