Table of Contents
Advertisement
75
Monitor
out
VIDEO
L/Mono
AUDIO
3
R
COMPONENT VIDEO INPUT
OUT
x
j
VCR
Connect Peripheral Equipment
Video recorder
&
é
CABLE
AV 2
AV 1
in
in
Y
S-VIDEO
Pb
Pr
&
é
"
'
(
There is a wide range of audio and video equipment that can be connected
to your TV.The following connection diagrams show you how to connect
them.
Connect the RF cable 1 to the RF socket x of your video recorder.
Connect another RF cable 2 from the output j of your video recorder to
the input x of your TV.
Better playback quality can be obtained if you also connect the Video, Audio
Left and Right (only for stereo equipment) cables 3 to the
Mono and
input
AUDIO L/
R
Note: in case of mono equipment, only the left loudspeaker reproduces sound.
Use a mono to stereo adaptor (not supplied) for sound reproduction via all
internal loudspeakers.
The
connectors can be used for daisy chaining or to record
MONITOR OUT
programmes from your TV. See Record with your video recorder, p. 18.
quality with a S-VHS video recorder is obtained by connecting
S-VHS-Video
the
cable with the
S-VHS-Video
recorder to the
input. (See the instructions of your video recorder.)
VIDEO
If the cables 3 are not used the following steps are required:
Search for and store the test signal of the video recorder
Unplug the RF cable 1 from the RF socket x of your video recorder.
Switch on your TV and put the video recorder on the test signal or play a
prerecorded tape (See the handbook for your video recorder.).
Search for the test signal of your video recorder in the same way as you
searched for and stored the TV signals. See Installation, Store TV Channels,
Manual Tuning, p. 5.
Store the test signal under programme number 0 or between 90 and 99.
Replace the RF cable in the RF socket x of your video recorder after
you have stored the test signal.
Connect Peripheral Equipment
.
AV2 IN
input instead of connecting the video
S-VIDEO
,
VIDEO
15
Advertisement
Table of Contents
