Table of Contents
Advertisement
BERNINA Stitch Regulator (BSR)
10.2 BSR mode 1
The BSR function can be controlled via the foot control or with the button «Start/Stop». Start the BSR mode.
At the BSR presser foot a red light is on. By moving the fabric the machine accelerates. If the fabric isn't
moved, securing in place is possible without pressing an additional button. When working via the foot
control or when using the button «Start/Stop», the BSR mode doesn't stop automatically.
10.3 BSR mode 2
The BSR function can be controlled via the foot control or the button «Start/Stop». The machine starts only
when the foot control or the button «Start/Stop» is pressed and the fabric is moved simultaneously. Without
moving the fabric, the BSR2 modus stops after about 7 seconds. The red light goes off (only when working
with the button «Start/Stop»). When working via the foot control, the red light doesn't go off.
10.4 BSR function with Straight stitch No. 1
This function allows free-motion quilting with straight stitch and a pre-programmed stitch length up to 4
mm. The programmed stitch length is maintained within a certain speed, independent of the fabric
movement.
10.5 BSR function with Zig zag No. 2
The zig zag can be used e.g. for thread painting. The set stitch length will not be maintained when sewing
the zig zag stitch, but the BSR function simplifies the application.
10.6 Sewing preparation
Attach the BSR presser foot
NOTICE
The lens of the BSR presser foot is dirty
The machine doesn't recognize the BSR presser foot.
> Clean the lens with a soft, slightly damp cloth.
> Raise the presser foot.
> Raise the needle.
> Switch the machine off and disconnect it from the power supply system.
> Push the clamping lever up.
> Remove the presser foot.
> Insert the BSR presser foot upwards over the cone.
> Press the clamping lever down.
137
035964.50.04_2014-08_Manual_B790_EN
Advertisement
Table of Contents
