Table of Contents
Advertisement
Adjusting the sound
H
& Press
, select the SOUND option (
L
press
.The SOUND menu appears :
SOUND
• PICTURE
• LEVEL
• SOUND
• EQUALIZER
• FEATURES
• INSTALL
• SURROUND MODE
• DELTA VOLUME
• STORE
• AVL
• CORDLESS
• DELAY
I J
é Use
keys to select a setting and keys
K L
to adjust.
Note: to access the AVL, CORDLESS and DELAY
settings (hidden at the bottom of the screen) hold
J
down
key.The CORDLESS and DELAY settings
are only availables if surround loudspeakers are
connected to the TV set.The DELAY setting only
appears in DOLBY PRO LOGIC and HALL
SURROUND modes.
" Once the necessary adjustments have been
made, select the option STORE and press
to store them.
' To exit from the menus, press
Adjusting the sound
This menu allows you to balance the sound
between the different speakers.
H
& Press
, select SOUND (
The SOUND menu appears :
SOUND
• PICTURE
• LEVEL
• SOUND
• EQUALIZER
• FEATURES
• INSTALL
• SURROUND MODE
• DELTA VOLUME
• STORE
• AVL
• CORDLESS
DELAY
é Select TEST and press
A continuous sound is emitted in turn from
each channel : left, right, centre and rear
8
J
) and
120 HZ
500 HZ
1500 HZ
5 KHZ
10 KHZ
L
R
.
l eve l
J
L
) and press
TEST
BALANCE
CENTRE
REAR
L
to set it to ON.
Description of the settings:
• LEVEL: to balance the sound between the
different speakers (see below).
• EQUALIZER: to adjust the sound tone (from
bass: 120 Hz to treble: 10 kHz).
• SURROUND MODE: to select the different
surround modes (see next page).
• D E LTA VOLUME (volume diffe re n c e ) :a l l ow s
you to compensate for the volume diffe re n c e s
b e t ween the diffe rent programmes or the EXT
s o c ke t s .This setting is available fo r
p rogrammes 1 - 40 and the EXT socke t s .
• STORE: stores the sound settings.
• AVL (Automatic Volume Leveller): automatic
volume control used to avoid sudden
increases in volume, particularly when
changing programmes or during
advertisements.
• C O R D L E S S : to adjust the diffe rent parameters
of the cordless surround speakers (see p. 1 7 ) .
• DELAY: to adjust the delay of surround effect
on the rear loudspedakers (31 is the default
value).
(depending on the selected surround mode).
Remark : the rear channel only appears if surround
speakers are connected to the TV set.To change
.
the surround mode, press the
" Select BALANCE, CENTRE or REAR and use
KL
the
channel independently.The sequence stops
while the level is being changed and then
automatically starts up again.
' To stop the test, press
Levels may also be adjusted without using the test
signal.
( To exit from the menus, press
)
key.
keys to adjust the level of each
H
.
R
.
Advertisement
Table of Contents
