Basic Television Connection; Use & Care Of Remote Control - Philips 26HF5544D User Manual

REMOTE STANDBY POWER
POWER
FORMAT CLOCK SLEEP GUIDE
AV SAP CC INFO
AUTO
AUTO A/D
SOUND PICTURE
MENU OK
MUTE
VOL CH
1 2 3
4 5 6
7 8 9
0
A/CH
FRONT PANEL STANDBY POWER
(EXAMPLE)
USE & CARE OF OPTIONAL REMOTE CONTROLS
ITV_Nafta.indd 6

BASIC TELEVISION CONNECTION

ANTENNA CONNECTION
Connect the antenna or RF cable signal to the 75 ohm RF 'F' connector
·
socket located on the TV.
MAINS CONNECTION
Ensure that the mains voltage and frequency are correct. Please refer
·
to the product labelling and documentation.
Note : The power button on the TV does not disconnect the television
from the AC mains. It toggles the TV between on and standby mode. To
completely turn off the AC mains power, you must unplug the AC mains
plugs from the wall socket.
SWITCHING ON THE SET
Press the power button on the TV or on one of the optional remote
·
controls to switch the TV set on.
Note : If the TV is in commercial mode, it might not respond to the front
panel or the remote control. Please refer to the section on TV Installation
and TV Setup Menu in this documentation for more informaton.
To load the supplied batteries into the remote control ;
- Remove the battery compartment lid from the back of the remote
control.
- Insert two AA-sized batteries into the battery compartment, making sure
the positive + and negative - polarity line up correctly as indicated
inside the case.
- Reattach the battery compartment lid.
Note : Always remove batteries from the remote control if it is not used for
a long period of time. This is to prevent damage to the remote control
due to battery leakage.
6 6
2006-10-05 5:41:21 PM